View Full Version : UPA USB -reading HC05E6 (for big IR key)
cyrixcard
21st March, 2011, 11:31 AM
Has any one used UPA USB to read OLD, big MB IR key with motorola HC05E6 MCU
Does UPA have adapter to solder this MCU on. Please help me. i bought UPA for this HC05E6 so i feel frustrated
jokersat
21st March, 2011, 01:52 PM
on board you can read and write this mcu
must lift pin irq = vvpr and solder 8 wires
tested 100/100
@+
davorOS
21st March, 2011, 04:21 PM
I use pomona clip for my UPA,and only lift pin 1,also oscillator set to 2000Mhz
regards
bali motor
22nd March, 2011, 05:05 AM
Has any one used UPA USB to read OLD, big MB IR key with motorola HC05E6 MCU
Does UPA have adapter to solder this MCU on. Please help me. i bought UPA for this HC05E6 so i feel frustrated
lift pin 1 reading on board. oscillator set to 2000Mhz
cyrixcard
22nd March, 2011, 06:04 AM
where do i find flat cable for UPA - USB. I bought from China and they did not include any cable
cyrixcard
22nd March, 2011, 06:12 AM
do you have diagram for reading MB IR NEC key too
Thanks for the HC05E
bali motor
22nd March, 2011, 06:20 AM
where do i find flat cable for UPA - USB. I bought from China and they did not include any cable
this adapter for upa. include for hc05e6
Adapter for UPA-USB (http://www.ecuvonix.com/adapters-upausb-p-323.html)
for nec you use this tool:
OBD Space - BMW smart key programmer - Mercedes Benz Smart Key Programmer (http://www.obdspace.com/en/Products/Mercedes-Benz-Smart-Key-Programmer-product_85.html)
but just for write, can't for reading
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.