2002 bmw 318 i a/t e46 ews

[drivesure]

i have bmw that drove in to me for a spare key. i read the info with ews kline reader. zedbull/tmpro does not recognise the file. i take d46j chip off the board and read the dump with omega. same result. could anyone have a look to see if the dump can be repaired. thanks

[puu]

Pls tell us yyour ecu number.
If possible I post full dump ews and ecu.

[drivesure]

bosch 0 261 209 005

dme 7 519 592

what do i read in the dme?

[puu]

Read flash.
Post the duump

[Maxpower50]

I have same problem

bosch 0 261 209 005

dme 7 519 592

Here Duom From ecu Eny Help to get ??

[drivesure]

hi maxpower, what did you read on the ecu. did you read the 95080 eeprom in the ecu

[drivesure]

ok sorted the problem - read st95080 on ecu from another car . max power here is dump for ecu and ews attached. make key to start the car.

[Maxpower50]

hi maxpower, what did you read on the ecu. did you read the 95080 eeprom in the ecu
I read the ecu Whith KessII Master programmer .

Were can i locate the 95080 eeprom in the ecu?

MENY THANKS SO LONG

[simon77]

sorry why did you need to read the ecu to make spare key . only need to read ews.
the file you posted was not read ok.
regards

[drivesure]

dump damaged when reading. original key also dead. car was a non starter

[bali motor]

i have bmw that drove in to me for a spare key. i read the info with ews kline reader. zedbull/tmpro does not recognise the file. i take d46j chip off the board and read the dump with omega. same result. could anyone have a look to see if the dump can be repaired. thanks

what file you post. not file ews.
you post file ecu. and i will renew your ecu.
you must make new key from new file ews.
and make cyn with GT1 or INFA

[Maxpower50]

Here is the dump of ews I wrote in ak90 , So can i just program keys now OR how to du , Sorry i dont real understand ,

To make the key work in doors etc its one programm and to program the little loos chip in key another ??

[Maxpower50]

First I have to say big thanks to all who have helped me, Now start the car after having programmed it with the AK90,,, But the remote control does not, how I programmed it so that it works? + Eny Sugestion for me

[bali motor]

First I have to say big thanks to all who have helped me, Now start the car after having programmed it with the AK90,,, But the remote control does not, how I programmed it so that it works? + Eny Sugestion for me

see this for program remote key.:

Program and Reprogram Your Car Remote Key Fob Control Transponder - Program Your Keys Free Instructions - BMW 3-Series Key Remote Control Fob Programming (http://www.programyourkeys.com/BMW_3-Series_Key_Remote_Control_Fob_Programming.html)