View Full Version : 4x1 DiSEqC switch setup ?
r1c4ard
11th December, 2008, 09:36 PM
I am having real trouble setting up a Wave Frontier T90 dish, Global UK Communications 4x1 Switch and Dreambox DM500s with Gemini Image
LNB?s at 13, 19, 23 and 28 all with good signals
Switch Lnb 1 ? 13
Lnb2 ? 19
Lnb3 ? 23
Lnb4 ? 28
RX ? DM500
I just cannot get the receiver to switch to any LNB ??? any HELP would be appreciated.
cauliflower69
11th December, 2008, 10:25 PM
The switch may be faulty m8. Had that b4.
r1c4ard
11th December, 2008, 11:02 PM
The switch may be faulty m8. Had that b4.
Bought a new switch today as other one had a little surface rust when was exposed to water wanted to rule the switch out I think its more with the dreambox config from user error
cauliflower69
11th December, 2008, 11:05 PM
Can you borrow any body elses box and test it with theres ?
r1c4ard
11th December, 2008, 11:20 PM
Can you borrow any body elses box and test it with theres ?
Unfortunately cannot get hold of another Sat box but the Dreambox was switching with a 2x1 switch I also have
r1c4ard
12th December, 2008, 10:13 AM
Settings I have already tried?
From main menu
setting then service searching
sat config.
Non-stnd user defined config
my 4 chosen sat's created all other deleted
in lnb config for each sat
LNB0 then LNB1 for next sat etc
LOF/L 09750
LOF/H 10600 (universal)
Threshold 11700
Unticked increase voltage
Next page
Toneburst None
DisEqC Mode V1.0
DisEqC Parameter A/A
Sequence repeat unticked
Fast DiSEqC unticked
then for next LNB1
DiSeqC Parameter A/B
and so on for remaining...
Also tried DiSEqc Mode V1.1
as above with DiSEqc Repeats One (Only have a 10 Meter run) and none
Uncommitted Switch None and unit 1
Only have Swap Commands ticked
r1c4ard
12th December, 2008, 02:00 PM
Loose F Plug on receiver now all working used 4 sat config A/A A/B B/A B/B
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.