Is possible inmo off Golf IV 1.6 Magneti Marelli IAW4MV.?

[Valrod]

Is Possible inmo off for VW Golf IV 1.6 Magneti Marelli IAW4MV ?

Has anybody ever gotten?

i have read for flash 29F400 and eeprom 95080.

[kareszka]

Hi!
Wath is problem with ecu,on this model easy the ecu swapping.See this:
Immobilizer III ECU Swapping - Ross-Tech Wiki (http://wiki.ross-tech.com/wiki/index.php/Immobilizer_III_ECU_Swapping)
Regards

[VTS_Tibi]

no, it is not possible!

I just finished a VW Bora 1.6 16V IAW4MV today with immo problem.

Please write down what's the problem with the car and I hope I will be able to help you ;)

btw.: read my thread here:

http://www.digital-kaos.co.uk/forums/f178/bora-1-6-immo-problem-198239/

[VTS_Tibi]

yeah, if the dump is corrupted, just load a new dump into the 95080 - all IAW4MV dumps will be OK

then do the steps written down at the VAG-com site:


1. [Select] -> [01 - Engine] -> [Login - 11]

For the following procedure, use the PIN of the NEW(USED) ECU.


2. [OK] -> VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Do it!]


3. [Adaptation - 10] -> Enter 050 in "Channel Number" -> [Read]

For the following procedure, use the PIN of the OLD (ORIGINAL) ECU.


4. [OK] -> VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Save] -> [Done, Go Back] -> [Close Controller, Go Back - 06]


5. Switch OFF the ignition and let the car sit for ~1 minute, then switch ON the ignition again.


6. Verify that the NEW (USED) ECU now shows the VIN and if supported IMMO-ID of the vehicle now.



you'll need both the new dump's pin and the old dump's pin - which was in the car - today I've tried with the 4 digit PIN, and it was not successful, but with the 7 digit PIN it did without a problem ;)

you can easily make a 7 digit pin from a 4 digit pin with this programme:

http://www.digital-kaos.co.uk/forums/f178/4-7-digit-skc-code-convert-169374/