Renault Kango 1.5dci 2009

[markony79]

Info for members of DK

the micronas processor
The eeporm 93c76 can not read on the board
must take out and read ,work 100%


the reason for info:
the all pdf files from DP3, Dashcoder and Digiprog
not write that must take out

[markony79]

Did somebody have some info for reset service interval?

[RMCtech]

I don't know why but 93C76 memories are the most tricky memory to read by most eeprom programmers (there is a big risk of get a corrupted dump and programmer say successfully reading)

I have learned in the hard way to take all 93C76 out to read and never try to read them in circuit.

[dashradio]

I don't know why but 93C76 memories are the most tricky memory to read by most eeprom programmers (there is a big risk of get a corrupted dump and programmer say successfully reading)

I have learned in the hard way to take all 93C76 out to read and never try to read them in circuit.


DP3 will read Transit with 93c76 on board with no problems

[markony79]

DP3 will read Transit with 93c76 on board with no problems

Yes, I was before Trafic 2009 also with 93c76 ,and it work in cuircit, but its not the same dash

[markony79]

Service interval reset info

1. hold full pedal gas
2. put ingnition on nr 2 position
3. with right wiper control have 2 buttons( up and down)
4. use down button and go in meny on dash
5. choise the service interval
6. press and hold the down button
7. it will come the new service with 20000km
8. relase the pedal and ignition

:beer: