View Full Version : peugeot 307 2.0 hdi help
dannyuk89
17th April, 2011, 07:22 PM
im looking to remap my car 51 plate peugeot 307 hdi with a siemens ecu. i cant read its original map through obd but i can read its id and write. would you advise to write to it through obd if i obtain a mapped file with the same s/w and h/w no ????? to retrieve orig map i would have to remove ecu and read straight from eeprom
ecutuners
17th April, 2011, 08:17 PM
hi read in boot mode pin 28 of am29f400bt to ground remove feed and read in bootmode
grimmer
17th April, 2011, 09:08 PM
normally no probs reading these through obd, 110bhp ive read before with kwp2000 and galleto, make sure you select the right protocol.
del635
18th April, 2011, 02:14 PM
110 is bosch though mate.
ecutuners
18th April, 2011, 04:05 PM
if its siemens then no clone tool will read unless its in boot mode, put in boot mode read / write with galletto ok
grinovsky
18th April, 2011, 06:02 PM
to read with galetto you have to connect pin 22 for flash to gnd and you don't need this to write
dannyuk89
18th April, 2011, 08:58 PM
im not to bothered about reading my original map just dont dare wirte to it without my orig one for back up would you risk it ?
dannyuk89
18th April, 2011, 08:59 PM
im using kess v2 not a clone or galletto
grinovsky
18th April, 2011, 09:15 PM
im not to bothered about reading my original map just dont dare wirte to it without my orig one for back up would you risk it ?
always,start by keeping backup for original
thene you can make as you like
it's safty;)
dannyuk89
18th April, 2011, 09:51 PM
thats what i thought :D
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.