Help with W211 keys

[bluesky2010]

Hi all, Need help to check data of EIS , ESl and ECU. Car is 2003 W211, E320 USA model. Orihinal key was broken and I made new keys using Ak500. But newly made keys can not turn ignition. no responce. Actually owner put into car aftermarket alarm. and keyproblem arises. after few months can not recognize key. EIS part number is 211 545 06 08, inside hc12 maskset OK50E. is there anyone to check whether all data is good or not ? May be problem lies into EIS hardware? Any advise will be helpfull.
Thanks

[whiskymk]

Why u don't test ESL and EIS on bench?
If is ok then problem is in car.

[doslamer]

You can check it with this - http://www.digital-kaos.co.uk/forums/f178/mercedes-key-software-202996/

[starprog]

I think your eis is not ok
change it

[bluesky2010]

Yes I did check EIS and ESL without car, no responce. May be EIS hardware problem. Needs to be changed

[bluesky2010]

Hello All, I made flash recovery for EIS and now EIS is working. Key can turn ignition. Now facing with ECU problem. ECU -drive authorization- start enable=NO. So how to make synhrone between EIS and ECU ? How to virginize ECU-s eeprom 95P08? If virginize eeprom data should I need to coding with Star?
Any help appreciated.I attached eeprom data
Thanks

[mercis]

virginize eeprom data

[bluesky2010]

Will try and let results , probably after tomorrow. I'm far away from car.
Thanks

[bluesky2010]

Hello Mercis, Should I need to do coding with Star when change eeprom data(virgin), If yes how to do? SCN coding or different?
thanks

[sogaro]

Guess what, you have a working key here buddy

[bluesky2010]

Hello Mercis, I just came back and tried to write your data into 95P08 and it cannot . Data size error. ?? Also I have not tested key from Sogara. Will try both .
Best regards,

[bluesky2010]

Hello Sogaro, Yes it starts, whitout anychange, Just made your key and all original datas, Thank you very much.