c16man
29th April, 2011, 08:45 PM
Thought I would check out the ECM test mode while I had the chance. ( Replaced a ECM on Perkins 1106D )
How do you get in to ECM test mode? I know that it must be a blank ECM to begin with. And the ser no must not be programmed. Had a new blank ECM, installed it onto engine after flashing the ECM, connected with EST and I couldnt find the ECM test mode tab (under the service tab). Did I miss something? Do you need a certain EST/ET subscription?
Thanks in advance...
How do you get in to ECM test mode? I know that it must be a blank ECM to begin with. And the ser no must not be programmed. Had a new blank ECM, installed it onto engine after flashing the ECM, connected with EST and I couldnt find the ECM test mode tab (under the service tab). Did I miss something? Do you need a certain EST/ET subscription?
Thanks in advance...