SAAB 93 03y 2.2d need pin from cim

[ana_11]

Hi need pin from cim to saab.
2003y 2.2 psg16
my dump on cim 93c66.

[piticulto]

I get you personal message.

Your dump is corrupt.

check the read procedure..if you read on 8 or 16 bits

Check my good saab 9.3 dump
bye bye

[ana_11]

My cim readed ok

[piticulto]

PIN CODE : D7NH

REMEBER : TURN ON OFF 10 TIMES

[nanux]

Hi piticulto,
can you tell me what you mean by writing

"remember to turn on off 10 times" ?

to turn ignition on and of ten times and then put in pin code or what?
i have original Waux-com but how many times i tried put in security code keep getting mssage that is wrong.
i need to adjust stering angle sensor on saab 93 03 and for that i have to put in security code witch i extracted from CIM dump.

Is there some special way to do that?

Thanks.

[keygargoil]

Hi piticulto,
can you tell me what you mean by writing

"remember to turn on off 10 times" ?

to turn ignition on and of ten times and then put in pin code or what?
i have original Waux-com but how many times i tried put in security code keep getting mssage that is wrong.
i need to adjust stering angle sensor on saab 93 03 and for that i have to put in security code witch i extracted from CIM dump.

Is there some special way to do that?

Thanks.

are you sure its not B7NH

[Yura123]

Hi all!!!
Corrupted dump 24C04 in the instrument panel, need help in the restoration.
Write another dump in the dashboard, the car will not start. Read the dump CIM module - 93LC66A.
login UH5S correct? VIN YS3FD45D741019171

I enter my login through op-com, but writes wrong login. Need help - how can you solve my problem.

[Bllinda]

PIN CODE : D7NH

REMEBER : TURN ON OFF 10 TIMES


You had to remember 600 seconds? Where is the time to damp place?

[Bllinda]

Hi all!!!
Corrupted dump 24C04 in the instrument panel, need help in the restoration.
Write another dump in the dashboard, the car will not start. Read the dump CIM module - 93LC66A.
login UH5S correct? VIN YS3FD45D741019171

I enter my login through op-com, but writes wrong login. Need help - how can you solve my problem.

as it "s your problem solved ...? whether you are connected to the op-com?

[zoro1]

Did the car prog read pin correctly?Original one.
I ask carprog ,but till now no answer...

[zoro1]

So ,CARPROG read ok pin code from`SAAB psg16 -it is letters,but with OPCOM you can not make adaptation .