Renault Kangoo 1.9 DTI - EDC15 2Plugs

[Pali33]

Hi all,
i need immo off:
Kangoo 1.9DTI 59kW 2001
0281 010 502
EDC15
2 plugs, 121pin

eeprom 24c04

is it possible to immo off by 24c04? Or only with emulator? When emulator, which ECU-pin is immo line?
Thanks

[ammarben]

try this immo off

[Pali33]

thanks, but i have this file and i think, that only virgin, not off.
Are you sure, that your file is immo OFF? Must i disconnect immo-box or cut the immo-line?

[Pali33]

try this immo off
your off-file work not.
Can i use immo emulator in this ECU? (ECU has no CAN-Bus)

[neriuks007]

try and report

[albertros]

Hi,
Immo off isn't always a solution.
If the fault is the wiring then immo off will never solve the problem.

What is the immo light on the dash doing and what is the exact problem.

Thanks

[Pali33]

try and report
works your off-file 100%? Have you tested?


@albertros :
that's the problem. I don't know exact problem. I have only ECU, not car. The customer want eliminate the Immo-problem. Therefore i need 100% working solutiuon.

[neriuks007]

try connect emulator

[tomasete]

dash light is off, but when I switch on ignition, it blinks slowly
Any advice?
the remote works by the way

[LEONARD]

dash light is off, but when I switch on ignition, it blinks slowly
Any advice?
the remote works by the way
put 000000 all adresses it s work if car haven t climate

[tomasete]

put 000000 all adresses it s work if car haven t climate
sorry for my ignorance,
000000?s in the immo or in the ecu eeprom?

[medcapot]

i have your solution brother
change 24c04 chip by 24c16 chip and put this programme.
one think very important (not forget a smal thanks botton)
good luck

[tomasete]

hi everyone,
the kangoo is not working,
i did not do the change to 24c16 because i don?t have any now;
i repaired the file with immokiller but nothing
the immo file seems to be okay, pin code 7915
and t300 programs remote properly but... no start

[Pali33]

i have your solution brother
change 24c04 chip by 24c16 chip and put this programme.
one think very important (not forget a smal thanks botton)
good luck
you have forgot this: you must lift pin 7 and conect him to pin 8 (WriteProtect). This have i tested and its works.

[tomasete]

fixed it:
fuses problem thanks everyone