Peugeot BSI

[maaxxyy]

Hi guys i need some advice on Pug bsi with MC912DG128AVPV mcu on board. Is this secured or non secured? And do i need to read the flash or eprom to virginise it? Thanks

[JFR-Tuning]

Hi,

i know only that you must read the memory. Ihave a instruktion to read this and witch you can put the km of 0.
I know also that you can use abritus72 with obd2 to vergin it komplett. But it is very expensive

Frank

[maaxxyy]

Thanks for the reply, by my case is for virginising the bsi and not adjusting mileage.

[jackeldestripador]

SOmetimes you can "virginize" it with the programer, you find where in the dump is the vin number and erase it or change some numbers. Put back ok car and see, it will be clean.

[dunnnia]

Hi,where the VIN number is stored in BSI,I have one after waterfloud and second from other car and think replace the MCU with VIN

[kevfield]

UPA can do this pal just done one now :) UPA = non secured.

Thanks kev

[maaxxyy]

Thanks Kev, is it flash or eprom we need to read, of the 912?

[kevfield]

Just EEPROM to make bsi virgin unless flash has bad data but I can't see that.

Thanks kev

[tachonow]

This is virgin dump for your mcu eprom.

[Meat-Head]

*SPAM*

Just a thought and only a thought, if these bags of shite keep loosing there coding, vin immo etc etc.

Could you not try 10 volts on the bsi for one hour see if blanked?
then keep playing till you hit it?

Meat.