repair chinese cable back to KKL interface

[mig28]

Hello,

i hope u can understand my english ;)

I have an chinese cable it will be detected as Ross Tech cable,

after i experiments with VCDS.:afraid:

Give it any solution to flash the cable back to an chinese clone KKL cable.

Thanks for help.

kind regards
mig28

[micromax]

if you ross tech clone cable witch atmega inside you don`t make vag kkl. you must rewrite atmega with correct dump and eeprom from ftdi chip.

[mig28]

Hi,

thanks, can u give me the dumps or a link to the dumps.

which programm i must use FT_Prog or Mprog?

THX 4 hlp

mig28

[micromax]

atmega - stk300, xprog or other AVR programmer
ftdi - mprog
dumps you have in this forum. search it.

[mig28]

...
dumps you have in this forum. search it.

i didn?t found it. :(


i have use this solution


its programed for hex can cable:) use mprog and set to default VID/PID

at this time it is an KKL interface, but if someone have the dumps, plz send link

THX

mig28

[DB77AAA]

Try whith mprog to reconvert FTDI. I think you have blue cable KKLusb 409.1

[mishu_b]

...
open your interface - lock carefully to the biggest Integrated Circuit (CHIP) - write here what is there.

ex. FT232RL, FT232BL????

atb

[mig28]

... I think you have blue cable KKLusb 409.1

Yes, that?s correct
...
open your interface - lock carefully to the biggest Integrated Circuit (CHIP) - write here what is there.

ex. FT232RL, FT232BL????

atb

I do it today afternoon and will send feedback.

[mig28]

Hi,

it?s an FT232RL

see PIC1

Fdti
1012-8
89297701
FT232RL

on the other side is an chip too but i can only read

LM393
(see PIC2)


mig28