Help FAP remove audi A4 2.0 tdi 2007

[ZondaR]

I need help to remove this FAP from audi a4 2.0 tdi 2007
Audi A4 2.0 tdi 2007
Siemens
03G906018AQ
9971HR4

try 2.0 and not work,try to turn off all sensors plugs not work,dash ligth cames up all the time.

Can anyone help me please.

[lupu_sandu]

Fell free and try this file (chksum OK)

[ZondaR]

Fell free and try this file (chksum OK)
try just now and still with same problem,,fap is active on dashboard
i READ this os they website,,can be this the problem???

13.12.2009. DPx - EEPROM editor added.
In cases, when even after removing FAP/DPF there is blinking lamp at dashboard, this means, that level of FAP at moment of removal was over critical point (vary from car manufacturer to car manufacturer). Usually it is over 200%. This value is stored in EEPROM and must be cleared (set below threshold). EEPROM editor is added to ECUsafe. Read EEPROM and open binary file in ECUsafe. Point of FAP level storage will be detected automatically. Set it to any low value (or zero). Export file and program EEPROM with it. EEPROM checksum is calculated automatically. Blinking lamp will disappear.
HELP wanted ! Please help me send me EEPROM files from cars from VAG, PSA and Ford - I want to add all their structures to EEPROM editor and I don***8217;t have enough examples to do this with 100% accuracy.

[lupu_sandu]

So, open ECU read eeprom and post here.

[vanya86]

I try on this car to make FAP OFF with 3 different soft.

ES 1920 ES 2 and something else.

But still lamp on dash and engine in safe mode.

[b5conversion]

Believe me I`ve tried almost everything ,

they work sometime than car goes limp mode but you won`t feel because ecusafe changes limp torque limiter .

if you change to ori limp torque limiter you`ll notice that ecusafe
changes the torque limiter .. dangerous !