View Full Version : Micronas Dash Golf V
chriskross
18th May, 2011, 11:57 AM
Hello
i have a broken leg of a micronas 3217G :banghead:
does anyone know a adress to buy a new one.
bg chris
exe123
18th May, 2011, 12:12 PM
codecard.lt
btw. cdc3217 will still work without the two pins you have to lift.
chriskross
18th May, 2011, 01:26 PM
codecard.lt
btw. cdc3217 will still work without the two pins you have to lift.
Hi
you mean i don't need to solder the 2 cables TDO, TEST2
or i have to solder without lift the pins? :adore:
bg chris
exe123
18th May, 2011, 01:37 PM
dash will still work if pins are broken but of course you cannot connect via jtag. you have to do the dash via obd now.
chriskross
18th May, 2011, 02:00 PM
problem is i don't have pin of this dash so i can't do the job by obd, or do you know a solution that i can read by obd without have a valid key?
exe123
18th May, 2011, 02:04 PM
yes but I will not share it. sorry
chriskross
18th May, 2011, 07:56 PM
please tell me what is the best way to lift up the pins, do you have special tools for it.?
autofan1965
18th May, 2011, 10:48 PM
In my region scalpel is number 1 solution.
milesbetteroff
18th May, 2011, 11:15 PM
Hi mate I use a syringe well just the needle from it it's nice and fine but still strong enough to lift the pins works well for me
chriskross
24th May, 2011, 01:27 PM
can someone send me flash and eeprom dump from this dash 1K0920874B please.:dancing2:
baleyba
27th May, 2011, 10:41 AM
Hi chriskross,
I hope this will help you.
If you know how to enable needle illumination always on, please keep me informed ;)
regards,
Bal.
gselectric
19th November, 2014, 08:10 PM
please my friends i got broken pin from same mcu even i couldnt manage to read the mcu because xprog m was giving me cant bypass security when i put back the dash it dead any help my friends ?
gselectric
19th November, 2014, 08:10 PM
the dash is octavia 2007 1z0 920 842b and it got same mcu
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.