quad lnb

[Shady]

lo lads :) am getting my new dish set up soon
80cm dish
motor
quad lnb.

the quad lnb will be using 3 coax cables atm, ive seen a set up for a single lnb and the coax goes from lnb to motor, then another coax goes from motor to receiver.
my question is.. how do i fit the 3 coax cables from lnb to the motor? do they all have to be fitted?

[dick b]

no mate just one cable from lnb will go to the motor then on to your main set top box which will contol the dish movement the other three outlets can be used for other set top boxes but only on the the same satellite as the main box and will go direct to those boxes or you could use 1 feed for a twin tuner box if wanted

[Shady]

its as i thought then..just needed it clearing up thanks mate :)

[setfiretorain]

I'm going to setup a 80CM motorised, they difficult ?

[mdt]

I'm going to setup a 80CM motorised, they difficult ?


as long as you get your mounting bracket 100% plumb then its just a case of following each step carefully to peak your signal. take your time and make very small ajustments and you will be fine. regards mdt

[setfiretorain]

I'm not good with patients, But i gotta learn some day aye ?

Regards.

[dick b]

I'm not good with patients, But i gotta learn some day aye ?

Regards.

try this guide for a spiderbox mate it may help

[setfiretorain]

Ill be setting the 80cm up with a DM500S mate.