PDA

View Full Version : Rolls Royce Phantom 2007



z786
24th May, 2011, 06:37 PM
Hi,
got 1 to do, what can i expect?

what do i strip out?

how long will it roughly take?

if its same as 7 series then will cas go via cluster plug?

thanks guys

T72
24th May, 2011, 06:51 PM
pdfs from enigma, loks like e65... cas with 912.

smartymarti
24th May, 2011, 07:43 PM
its a bmw 7 series cas3 and 35080 in dash

diagtech
24th May, 2011, 09:45 PM
Remove 3 silver rods that are used for opening and closing vents just unscrew,above cluster 2 t20 and 2 phillips pull strip that goes all way across dash just pulls up remove 2 panels with vents,remove with 2 t20 panel below clocks again after strip removed then 4 t20 for cluster when cluster is out i use small cutters that i use for discovery mcu to remove several white plugs then remove t10 screws and cluster will come out of case 35080 same as 7 series,cas unit remove all t25/t30 bolts and 3 10mm bolts to remove leather pad under steering column and then full unit where you insert key and light switch,i always use original rosfar either -2005 or 2005- depending on year rosfar will say not verified when reading but program anyway done about 10 of these definitely works,only problem i have had is trying to put less than 50 miles will show 999999 but 90 miles is ok took me 2 hours to find this out,not as bad as you expect.

milesbetteroff
25th May, 2011, 04:45 PM
Hi mate i think you must have taking tea breaks while doing that job it takes no longer than 40 mins start to finish it's a good job nothing like taking out a e65 that mite take 2 hours if you where not to sure where things are but it's a easy one for you z786 good luck

TULGEYWOODMAN
25th May, 2011, 11:25 PM
Hi mate i think you must have taking tea breaks while doing that job it takes no longer than 40 mins start to finish it's a good job nothing like taking out a e65 that mite take 2 hours if you where not to sure where things are but it's a easy one for you z786 good luck

Tea breaks or not, hes done 10 of them .
.
.
.
.

Meat-Head
25th May, 2011, 11:50 PM
if the bloke can afford one of these, he can afford a decent set of jump leads

florinyes
25th May, 2011, 11:53 PM
Battery goes flat on these too?

wiseman
26th May, 2011, 12:21 AM
another jump leads joke beef chief.....

v-diag
26th May, 2011, 03:15 AM
had problems with the cas on these the enigma and original rosfar would not read the right value. rosfar said verification failed?

so made a full back up off the flash and eprom then just changed the miles with the rosfar.

at the end it all worked out, and everything thing worked?

:dancing2:

milesbetteroff
26th May, 2011, 09:28 AM
Hi everyone I have only done 2 off these but I gess I will get quicker at these the more I do how are you wiseman not spoke to you for while anyway back on track disconnect battery before you start it saves it going flat that should give you time for a wee cup of tea : )

wiseman
26th May, 2011, 11:33 AM
Hi everyone I have only done 2 off these but I gess I will get quicker at these the more I do how are you wiseman not spoke to you for while anyway back on track disconnect battery before you start it saves it going flat that should give you time for a wee cup of tea : )

Its been far to long, need to catch up soon, hope you and steven are all good mate