View Full Version : CITROEN C2 VTS IMMO OFF
ernesto1670
27th May, 2011, 11:09 AM
Hello `s dk
I have a Citroen C2 1.6 16
ECU: ME7.4.4
0261207999
I need to remove the immobilizer. If not in the (flash 29F400) or (eprom 95160)
Attached the two readings.
I appreciate the help
adam28
30th May, 2011, 07:04 AM
Here mate,your off files. Dont forget to cut F3 and F4 in middle connector of ECU
ernesto1670
15th June, 2011, 11:19 AM
Program the 95160 29f400 and the files you sent me, cut f3 and f4 and the car will not start.
elosomaloso
17th June, 2011, 05:23 AM
Look here
http://www.digital-kaos.co.uk/forums/f178/m7-4-4-immo-off-needed-picasso-168413/
ecufix
17th June, 2011, 01:02 PM
Here mate,your off files. Dont forget to cut F3 and F4 in middle connector of ECU
On the c2 I dont have f3 f4 in the harness and car dont start, however on a peugot 207 with the same ecu loaded the dumps cut the wires car starts , thanks for that but still need solution for c2
please regards
ecufix
19th June, 2011, 11:36 AM
please Adam
adam28
19th June, 2011, 04:18 PM
please Adam
Hi mate
Sorry i dont have other solution.
ecufix
20th June, 2011, 07:31 AM
thanks anyway .
ecufix
20th June, 2011, 07:59 PM
Using software for the peugot me7.4.4 the C2 is threatening to start ,I have spark and injection pulse as well as fuel pressure . No diagnostic scan has been performed whilst using above mentioned software .Question is , are the timing plates and other tdc references the same ?
regards
ecufix
21st June, 2011, 03:56 PM
Car (C2) started using peugot ecu with adams28 immo software
So as far as I can figure out , m7.4.4 does appear to be the same . thanks all for help
best regards
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.