Liton 7485 - Need Help [Sitemap]

braindead

27th May, 2011, 04:32 PM

AAHHHHHHHH... can anyone help, I updated on Xbox live, and then tried to reflash. However, Jungle flash wont provided me back a valid flash.

I done the Liton erase, and when it does an intro/device it just comes back with the following info, even though i'm turning it off and on during the second line of dots.

Sending Lite-On-Erase request to port 0xB400
..............
Drive returned Status 0x7F
....................
Device Intro failed!

If it doesn't provide a valid Staus I cant read the firmware

Any help appriciated, im nearly there...

janobi

27th May, 2011, 04:55 PM

AAHHHHHHHH... can anyone help, I updated on Xbox live, and then tried to reflash. However, Jungle flash wont provided me back a valid flash.

I done the Liton erase, and when it does an intro/device it just comes back with the following info, even though i'm turning it off and on during the second line of dots.

Sending Lite-On-Erase request to port 0xB400
..............
Drive returned Status 0x7F
....................
Device Intro failed!

If it doesn't provide a valid Staus I cant read the firmware

Any help appriciated, im nearly there...

You cant read the fw if its been updated mate. You need an MRA hack to get the key. If you have the dummy.bin then just erase and rewrite.

braindead

27th May, 2011, 05:07 PM

I know I cant read the Keys, but when I do a device intro it has to provide vaild flash properties before I can erase / right

MrFug

27th May, 2011, 07:25 PM

Pretty sure the MRA hack has been superceded by the PMT Probe method. Much easier and doesn't require any trace cutting, just a 3.3v switch on your connectivity kit cable.

Braindead I think I remember having the same issue. I think it's just a case of turning off / on and hitting Intro and the right time. Not 100% sure though.

cunny

27th May, 2011, 08:03 PM

Are you using VIA card? I hope you have the correct key? If you've erased the drive (by sounds of it you have) You will need to Send Intro to same port, turn off the drive, wait 3 seconds, power back on. The drive should reappear in flash properties.

janobi

28th May, 2011, 10:28 AM

Pretty sure the MRA hack has been superceded by the PMT Probe method. Much easier and doesn't require any trace cutting, just a 3.3v switch on your connectivity kit cable.

Braindead I think I remember having the same issue. I think it's just a case of turning off / on and hitting Intro and the right time. Not 100% sure though.

It does indeed, but if the drives been updated then the PMT dont work, and an MRA hack is required.