inmo Rover 25 eeprom 24C04

[Valrod]

Can someone help me cancel inmo a Rover 25 with eeprom 24C04 ECU Bosch 0281001956

Thanks

[Valrod]

Anyone know the procedure for this car?

[chiptorque]

this is like the opel ... I advise you to cut the pin 35. to me it has worked ... but the file is not correct ... try this ...

[Meat-Head]

did this work

[giuliani77]

Good question.This thread was in year 2011 all thanks was post after 5 years and nobody share if the solution is good or not.
So please share if work and must cut pin 35 or 37.

[pwrider]

484639
With this file car works 100% - checked in my workshop
But you have to:
1) cut immo line pin 37 (blue/gray) of engine ecu
2) give additional ground on relay called "SM" in engine fusebox (starter motor relay)
3) remove alarm module (behind radio) and desolder buzer from inside
4) cut 4th pin from the smallest plug (3rd one) blue/pink - this is red immo diode on dash
5) if engine check light is on cut also pin 42 of engine ecu (YELLOW/RED OR GREEN/RED)

Works fine

[andrej2003]

tested and running 100% , but how to turn off the alarm.

Rover 25 2.0 td, 2004, Bosch ECU 0281001956

[Meat-Head]

Try starting and stopping 50 times as lupu says cuts back in

[ivodeshev]

Guys I want to thank you. The file works fine. I cut the line of the immo directly from the immo box , also cut the starter relay cable. Additional ground to the relay and the starter also work fine. WIth this config you still can use the central locking function. Thanks again :)

[qwertyuiop12]

Hi all,Rover 45 2004,I made immo off files 24c04 no_immo (https://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=484639&d=1510216545) ,car start,but how to turn off the alarm ?
Alarm modul 4 connectors,I tried to completely turn off the unit, but the central locking does not work,
the interior light, everything that is responsible for comfort not work.

[marianolopez]

I have a problem with a similar ecu. I will try to see if it works. Thank you



484639
With this file car works 100% - checked in my workshop
But you have to:
1) cut immo line pin 37 (blue/gray) of engine ecu
2) give additional ground on relay called "SM" in engine fusebox (starter motor relay)
3) remove alarm module (behind radio) and desolder buzer from inside
4) cut 4th pin from the smallest plug (3rd one) blue/pink - this is red immo diode on dash
5) if engine check light is on cut also pin 42 of engine ecu (YELLOW/RED OR GREEN/RED)

Works fine

[Adrigaaas90]

484639
2) give additional ground on relay called "SM" in engine fusebox (starter motor relay)
Works fine
Sorry about my ignorance. How can I do that? Thanks

[Adrigaaas90]

Sorry about my ignorance. How can I do that? Thanks
Nobody can help? Please, I need some help with the relay cable.
Thanks

[Meat-Head]

Nobody can help? Please, I need some help with the relay cable.
Thanks

Welcome to dk the worlds best website.

from memory i *THINK* locate the immboliser module that in cente console
THINK black/orange. When you hold the key to crank become positive. Going through a starter relay
Somewhere in the middle of the plug.

find that wire hold key over flash a negative see if it cranks. ‘Next to’ it is black wire join them t’gether.