PDA

View Full Version : suzuki gran vitara immo off



latino
31st May, 2011, 08:32 PM
i m8 there is some solucion for immo off suzuki gran vitara ..thanks

tuberider
1st June, 2011, 07:37 AM
..same problem over her m8, i switched ecus and swapped all ecu content but vitara is not starting, even not with the original ecu anymore, the eeprom data changes every time.

immokill
1st June, 2011, 08:06 AM
HELLO

You need TECH2 with Suzuki card ,to SYNC ecu\immo.
I also searched for solution and that was the only one.



Regards

latino
1st June, 2011, 01:24 PM
you also have this problem ? with that solucion everithing its ok ?? so impossible immo off !!

tuberider
1st June, 2011, 02:37 PM
im going to the Suzuki Dealer next door, he will do it with the Suzuki Diagnostic , sometimes that way saves so much time

newtronic
1st June, 2011, 02:44 PM
I have read somewhere
that if taking out eeprom you solve the immo problem
I think eeprom is TPLxxx

MrKey
1st June, 2011, 02:47 PM
Hi, Use the original Scanner or SBB and you?ll have a quick solution. You don?t need the code.

latino
1st June, 2011, 06:00 PM
im gonna get the sbb and i will try thanks

mazilus007
1st June, 2011, 07:16 PM
you do something? I got a same problem for a week and I could not find a solution. Thanks

BATLER
1st June, 2011, 07:40 PM
SBB didnt work for me

it only write keys in immobox but cannot

adapt engine ecu-immobox

solution was:

TECH2 with suzuki software

latino
1st June, 2011, 10:59 PM
could some on tell me where i can get tech2 whit suzuki card (software)...thanks

immokill
2nd June, 2011, 04:30 AM
You only need to find TECH2 with card,everything else is here on DK.


Regards

latino
3rd June, 2011, 01:16 AM
im looking for ,,thanks

latino
19th July, 2011, 01:09 AM
hello m8 i buy a clone tech 2 i think is not the correct card can you give me a hand on this thanks

http://www.digital-kaos.co.uk/forums/f172/tech-2-help-217884/#post1180128

tellfaia
19th September, 2011, 03:00 PM
hi, is your grand vitara with keyboard code? 2.0hdi with edc15c2 ecu?
I know the solution for that without tech2.

mariusf11
21st October, 2011, 09:57 PM
I have a problem with a suzuki vitara 2.0 petrol ,1997 year . Battery run flat and after new replacement engine ecu lamp start flashing and no start. I think that the keys were erased from the ecu memory. If someone can help me to repair the ecu dump i would be very grateful. I attached the ecu hitachi 3392078EN eprom oki m951G dump, immo 33970-70E02 eprom 24C01 dump and the 4C key in TIRIS format . Thanks in advance.