Reading Atmeg with upa

[kaToo]

Hi all
Does anyone know how can i read the atmeg procesor from Vag Com 10.6 with UPA_UsB

I destroy my vag come with one new software and now i need to flash the atmeg with a new dump ...
Is it posible to read it with upa ... (with wich adapter shuld i read)

THANKS

[fifas2010]

Hi all
Does anyone know how can i read the atmeg procesor from Vag Com 10.6 with UPA_UsB

I destroy my vag come with one new software and now i need to flash the atmeg with a new dump ...
Is it posible to read it with upa ... (with wich adapter shuld i read)

THANKS
I never try...but with ponyprog is 100%
But you have dump to reflash vagcom 10.6 ?

BR, Fifas

[kaToo]

to tell the troth NO but i think i can find in the near future
I just wondered if i could read

THANKS

[fifas2010]

to tell the troth NO but i think i can find in the near future
I just wondered if i could read

THANKS

Yeah buddy, but the problem is not read or write .. the problem is to have a dump to reflash the ATMEGA162 and 232rl ept file,to version 10,6
this is the real problem!

good luck ):

BR, Fifas

[rsibiza]

When using original UPAUSB there is a folder how to connect..wire up between upa and atmega...

U need an DB9 connector to solder some 6 wires as described in the folder i mentioned...for ATMEGA162

Best is powering up the atmega by upa also,no external supply...

Need first read fusebits from working one...if need,i can post how they should be...

*Erase flash erase eprom

*Open first eprom hex,close fusebits select

Atmega162 eeprom write

*Open flash hex,close fusebits select

Atmega162 flash write

Disconnect BD9 connector from upa,and power up by 12V the interface...check if led turns to green...Done

In the vcds everything is posted for free last vcds11.2 hexdump to use with ori vcds sw...good luck

Br. RS