bmw e36 immo off possible?

[smokinjoe]

i have a 1998 bmw e36 318is with a bosch M5.2 M44 DME,is it possible to immo off this model without emulator as i have tested the coil,amplifier,key,continuity to from amplifier to immo box and all is ok,also tried another immo kit but still no crank so i don't suspect the ews2.
it will crank if i bridge wires at the ews but obviously not start.
dtc for ews is:-key 3 not recognised and in DME 1 fault 148 relating to interface immobiliser.
all help would be much appreciated

regards:smokin:

[elephantul]

try to cut pin 66 to ecu and bridge pins an ews to cranck

[smokinjoe]

try to cut pin 66 to ecu and bridge pins an ews to cranck

does this method need any programming and has it worked for you?

[smokinjoe]

according to autodata pin 66 is not connected?

[elephantul]

no need programing, solution is tested by my, but i don't cut pin 66 to ecu, i cut pin 7 round couple engine harness to car harness (black with violet, think, i don't remember very well). read somewere this pin 7 corespond to 66 ecu not sure for this, but 100% sure cut pin 7 from round couple. car i whorking is E36 diesel with broken engine, remove engine and put engine gasoline 1800cm3 from another E36 exactely 318 is and car wont start, after many attempts and many cut wire found this solution

[smokinjoe]

sounds good elephantul and will try tomorrow,could you help with more details on the location of pin 7 and the round couple,where is this?
thanks.

[smokinjoe]

ok i think i have it,its the wire that goes to the round connector pin 7 violet/black to green pin 10,immo,of dme so will try this and let you know results
thanks again.

[eduardo74]

And did you solve this bmw?