ST10Flasher - help to save file

[borysgo2]

Hello
I have small problem to save file from mm6lp ecu (+12,gnd,k line, boot mode resistors connected).

My problem is (i dont know how to save HEX file): when i select as a target file destination st10flasher is logging error as in pic 2 (external flash monitor not found). When i select as target screen - im getting dump as in log box pic 1. Can someone explain me what im doing wrong please. Thanks

[samsai]

I have proplame in MM6LP2_03 not boot resistors connected plezz halp.

[borysgo2]

I found this in dk forum, hope will help.

Im just wondering if soeme o f st10xx based ecus can be readed and saved in text or screen mode only.

[jovime]

Did you check if your ST10Flasher installation is missing a file? Could be a missing or corrupted file.

Seems you're getting access to the processor and is reading well. Try to reinstall software, or install it on another PC.

[samsai]

i have this *LOAD MONITOR-->ERROR
Description: InitMonitor failed.
Monitor:
LoadMonitor: Bad aknowledge value 0xE6 instead of 0x5A.
Com: Receive: Timeout or Lost of data Psa IAW6LP2.03

[borysgo2]

I was playing with software many times and no good. I even desolder st10 micro and made Tx Dx pinout for x-prog - but it is freezing up after 40% so prapobly there is a bug in x-prog hardware/software. For now I just gave up.

[dimitar]

I was playing with software many times and no good. I even desolder st10 micro and made Tx Dx pinout for x-prog - but it is freezing up after 40% so prapobly there is a bug in x-prog hardware/software. For now I just gave up.

It works good for me, just use external power supply and RS232