polo 2007 magneti

[ION CRISTI]

hello. i need read proc 9s12h256 from dashboard vw polo magneti marreli. i use upa usb, i set osc 6000 and read succesuful but dump is fffff. please i need solution . thanks

[mastaflex]

use schema from x12 programmer for BDM points.

never have problem reading it. just try to reboot your pc and reconnect UPA. sometimes bad soldering gives bad dump

[atesbocusu]

lol :) same problem i have i wanna read upa mhz 6000 and clikc read but dont read i test car again but car dont start.. i try etl 912 tool but dont read.. :(

[ION CRISTI]

solved thanks. i cut pin reset

[potatodog]

lol :) same problem i have i wanna read upa mhz 6000 and clikc read but dont read i test car again but car dont start.. i try etl 912 tool but dont read.. :(
Dash totaly dead?
I have also a dead dash after reading 912....
Does anyone have a solution?

[alex_SW]

9s12 can be read by upa... let the osc auto...make connections like in manual...only 4 pins...same for protected 9s12x

[mastaflex]

9s12 can be read by upa... let the osc auto...make connections like in manual...only 4 pins...same for protected 9s12x


sorry mate , this dash specially need to set manually OSC.