toyota corolla very wire

[piticulto]

Hi

I have a toyota corolla 2005 with extrange ecu.

I need information about key generation or immo off.

the only epromm inside is on the backside ( not microiprocesor side) is a L56R, but this eprom have very few bytes.

Idont know if 4c or 4d67 or if is posible immo off, or the way to make the chips.

very thanks for all

[bram380]

ic 901 8-pin

[piticulto]

not have this IC901 , is empty.

only have on the micro side the ic801 , but i cant rede it

on the back sid eonly have l56r , i read like 93c56 but tha info is not about keys , few few bytes on the first line.

the micros are tdfp11-0003
and esp3 i guest

[bram380]

You can fix with two option:
- virginize immo
- read tiris key, and add to eeprom

[ray-ray]

use orange dongle do a quick reset and use 4d-67 chip.

[piticulto]

thanks ray ray
you say that i can use the smart orange chinesse key maker???

ok I will try

The ecu dont have a readeble eprom with good key information

I think that the ekey information is on the m,icros

[piticulto]

the car is really far away,

somebody are really sure about the program procedure.

this car not have immobox , and on the ecu i cant find out data key info.

the ecu is japan and the amplifier(see photo on top ) is made in canada.

The car is brazil.

[Bishop c4]

the car is really far away,

somebody are really sure about the program procedure.

this car not have immobox , and on the ecu i cant find out data key info.

the ecu is japan and the amplifier(see photo on top ) is made in canada.

The car is brazil.

why you chose to realize a job far,far,far away.... from you and knowing that you dont have the experience to realize that kind of job's......?

you first need to put in practice the advices of the DK experts and then only then ask again to others suggestions.

or maybe you need to ask the help of a real locksmith in your area to realize that kind of jobs for you.

just a thought... :party :

Regards

[cjawahir]

disconnect ECU and see if the immo light is still blinking , if it is you have immo box in vehicle .

cj

[keygargoil]

05 carolla definately has immo box 4d 67 remove top of dash and its tucked at the back near heater matrix vent you will need to be pre pared though cos if its japan version key id will start with 33, 53, 73 or 93
european 32, 52, 72 or 92
and one wont work the other

[diagnoza_auto2000]

05 carolla definately has immo box 4d 67 remove top of dash and its tucked at the back near heater matrix vent you will need to be pre pared though cos if its japan version key id will start with 33, 53, 73 or 93
european 32, 52, 72 or 92
and one wont work the other



Have same car with same problem ecu denso japan and immo tkay rika.I have made 3 keys 4 c .
Led go off but car not start.
Fault code:immobilizer malfunctions
I try to pair 10 times immo with ecu with the bridge 4-13 but not succes.
Please help!

[keygargoil]

have you damaged any of the feet on the circuit board post your dump and watch out for the little resistors when you heat the chip up they can slide and also blow of its happened to me a few times now

[diagnoza_auto2000]

I have try with many many dumps ,pairs ,virgins but not work.
Where did you think i have burn some resistor on ecu or immo?

[piticulto]

finally make the key thanks everybody.