clio starting problem

[spider2004]

hi friends
i have clio 2003 1.2
the owner of this car told me that the key is stopped starting the car.
i removed siemens uch ,read eeprom 93c66,extract pin code,prepared blank pcf7936(by chines zed bull),installed uch in the car, treiid to program the key(by t300-sbb),bin code is right,
but the big problem is KEY PROGRAMMED :0
I MEAN I CANT PROGRAM THE KEY

PLZ HELP
THANKS IN ADVANCE

[alfabit]

Did you try to program with DDT or CAN-Clip ?
If your PIN is correct, with those tools i said, it`s very simple. Best tools for Reno`s

[spider2004]

sorry only i have T300-SBB

DUMP FILE IN ATTATCHMENT
PIN CODE : D561F4C92187
THANKS

[nazz2]

When you turn the ignition on,do you see red light stays on or rapid flash or goes off?
also dont rely on the data that zbull clone has produced,try using an original id 46 renault transponder, but i have a feeling these dont turn on when you programm a normal transponer key, i always programm A remote key onto these after 2002!

[alfabit]

When you turn the ignition on,do you see red light stays on or rapid flash or goes off?

He can`t program key, for sure the immo LED is blinking rapidly.

@spider : did you respect the ID of the key, 33, 46 or whatever it is ? Do you know the ID for Reno Clio ? You must respect it, for the first programming ( that with zed-bull )

[spider2004]

He can`t program key, for sure the immo LED is blinking rapidly.

@spider : did you respect the ID of the key, 33, 46 or whatever it is ? Do you know the ID for Reno Clio ? You must respect it, for the first programming ( that with zed-bull )

thanks for all
i am sure it is 46,i think i will try prepare transponder then program it directly in the immo