PDA

View Full Version : c3 clone head to C4 tablet


clauberty
22nd June, 2011, 09:29 AM
Hello

It is possible to connect the clone head to the Original tablet C4

i open the clone had and the wires from the attached picture are missing, wires that connect the the round connectors

I suppose those are for charging ? or am i wrong ?

Of course i have to have the cable that go to the C4 tablet round connector

Thank you
DB_member
28th June, 2011, 08:28 AM
Hello

It is possible to connect the clone head to the Original tablet C4

i open the clone had and the wires from the attached picture are missing, wires that connect the the round connectors

I suppose those are for charging ? or am i wrong ?

Of course i have to have the cable that go to the C4 tablet round connector

Thank you

You could have posted a photo from your mux (similar to the example photo). I would not try it with your mux, you would likely burn the circuit board from the charging current for the tablet as you mention the additional wires are missing. In addition if you mux does not have these wires, it likely does not have an RS485 interface (even if it appeared to have an RS232 to RS485 converter box in its original PC cable).