View Full Version : Very need disk comes with BDM100 (v1255)
P2XA
24th June, 2011, 09:56 PM
Hi! anybody have SW. for v1255?
thanx
lolooo1981
24th June, 2011, 10:14 PM
Hi! anybody have SW. for v1255?
thanx
Here it is friend, with updaters.
Pass in PM
68875
P2XA
24th June, 2011, 10:38 PM
Next Message appears "communication interface error"
grinovsky
24th June, 2011, 10:45 PM
buy an other bdm100
P2XA
24th June, 2011, 10:54 PM
I connected via USB port BDM100 and +12 V applied through the power supply then started soft and pressed +12 V ON b saw a message "communication interface error" while at the same time hear the relay inside and LED lights. What am I doing wrong?
lolooo1981
24th June, 2011, 10:55 PM
is your BDM is connected to ECU when you put 12volt ON ? and the charger is connected?
in what ECU do you work ?
lolooo1981
24th June, 2011, 10:56 PM
I connected via USB port BDM100 and +12 V applied through the power supply then started soft and pressed +12 V ON b saw a message "communication interface error" while at the same time hear the relay inside and LED lights. What am I doing wrong?
Connect it to ECU before put 12V ON
Best regards
P2XA
24th June, 2011, 10:57 PM
edc16c3 PSA
z786
24th June, 2011, 11:04 PM
i had same fault, make sure pads are connected properly
lolooo1981
24th June, 2011, 11:14 PM
edc16c3 PSA
Normaly,no problem with this ECU.
Like Grinovsky if you have other problem change your interface.
File is 500k if i remember.
I do this ECU 3 times and no problem for me.
Best regards
lolooo1981
25th June, 2011, 12:14 AM
i had same fault, make sure pads are connected properly
BDM frame + adapters is the good tool you need.Official or good home made at your choice.
Best regards
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.