VW Crafter/Sprinter EZS

[z786]

Hi,
i tried to do a VW crafter 2008 today using rosfar clone
i kept getting verify error

what can it be?

thanks

[exe123]

check soldering and relink again. should work. i get that message some times on cas, after disconnect and relink it works

[z786]

i soldered 3 times but still got same fault, maybe it was my rubbish soldering

btw what temp you guys keep your soldering iron?

[exe123]

keep coax cable away from anything that could disturb the signal. cell phone, wifi hotspot, microwave and also from power.

soldering temperature is around 350?C sometimes more if your are working with lead-free solder

[tachonow]

Cut the coax at max 30cm length.

[z786]

coax is smaller than that
iv done loads of CAS and EZS with it
just was confused about verify error on this one

[antibisic]

keep coax cable away from anything that could disturb the signal. cell phone, wifi hotspot, microwave and also from power.

soldering temperature is around 350?C sometimes more if your are working with lead-free solder


I allways use 400-420 C and never get problem,I think is better more but very quickly solder than lower temp,maybe wrong

[teerak2uk]

what tools are capable to read/write to ezs modules on 2010 Crafter

many thanks

[smartymarti]

Enigma Rosfar dp3 plus the other usual auspects

[pinkfloyd5eg]

coax is smaller than that
iv done loads of CAS and EZS with it
just was confused about verify error on this one

have a look at this part from rosfar260 manual , hope if it can help !!

[wiseman]

do any of you guys use the gold clone?

[diagtech]

Had this with rosfar myself used dp3 instead goes straight away.

[Dumper]

Try to swift coaxial cables. Helped me one time when I had this problem.