View Full Version : renault megane remote
ninja123
6th July, 2011, 08:40 PM
Hi guys,
does anyone know the procedure for re using a remote for a 1998-2000 megane/scenic?
I have one that is (was) brand new, but has been programmed to a car already, but car now scrap so i keep key!.
I read in zedbull, it has ID 64 transponder chip.
I look in 3d keys, and says remote is re sync after transponder programming.
BUT! if i change chip for new one, how do i relate chip to remote or sync remote to car?
dont want to bin this remote as it cost over ?100 just to buy! so would like to re-use if poss.
ninja
SaieedEissa
7th July, 2011, 12:31 AM
press the central lock botton for more than 5 seconds with the ignition off ,the system will reply by Lock/Unlock, then press botton on the remote for 2 sec , Done , open the ignition for 5 sec............test
ninja123
7th July, 2011, 02:03 PM
press the central lock botton for more than 5 seconds with the ignition off ,the system will reply by Lock/Unlock, then press botton on the remote for 2 sec , Done , open the ignition for 5 sec............test
is this not just re sync info???
ninja
SaieedEissa
9th July, 2011, 12:34 AM
It's just what u need to do, even for a second hand remote
depredator
9th July, 2011, 02:42 AM
Hi ninja123,
This kind of remote key is imposible to re programing if it has been already used in another car, because it is closed and is imposible to re use it, also if you change the transponder you will not be able to programm it because each transponder is together with its remote.
ninja123
22nd July, 2011, 06:46 AM
Hi ninja123,
This kind of remote key is imposible to re programing if it has been already used in another car, because it is closed and is imposible to re use it, also if you change the transponder you will not be able to programm it because each transponder is together with its remote.
Transponder chip is separate inside key.
mrchip
17th February, 2019, 05:21 PM
I have same problem , how to program an used remote ( car is already immo off ) to megane scenic yr2001 ?
596658
immokill
17th February, 2019, 07:30 PM
It is possible if you have clip old version 85 or 90 there you have second remote adding in uch
Sent from my TELEFON
kiszka
17th February, 2019, 08:08 PM
I have same problem , how to program an used remote ( car is already immo off ) to megane scenic yr2001 ?
596658
it is not possible to add a used remote control
jacques23
17th February, 2019, 09:43 PM
carprog might do the job if you still have the 4 digit code pin stamped inside the key casing ive started some off these without a transponder hope it helps if it doesn't i see vvdi key tool can renew the remote
kiszka
17th February, 2019, 10:01 PM
carprog might do the job if you still have the 4 digit code pin stamped inside the key casing ive started some off these without a transponder hope it helps if it doesn't i see vvdi key tool can renew the remote
it is not an infrared remote control
https://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=596658&d=1550418502&thumb=1
mrchip
17th February, 2019, 10:32 PM
It is RF key with separate immo transponder, I dont have experience with key programming,,
transponderchip and remote does works separate or they have relation? need pincode from UCH to program remotekey ?
if I swap chip ( mc68hc705b32 ) from ori uch to donor uch does works remote ( that used one ) ?
jacques23
17th February, 2019, 11:00 PM
hi pm me the the nr stamped in the key casing then ill help you with the pin 4 the vehicle
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.