how can i update sbb v31 to v33?

[dam495]

hi guys, i took a sbb v31 from a friend and now i'd like to know if it's possible update to v33?and if it's possible what i will need?and what are the steps for to do it?all sbb v31 can update to v33 without brick sbb?a friend could put a video showing how to do it, or write step by step how to do it.

[dam495]

it's possible do it?

[jokersat]

yes by dumps if you are professionel soldring it is not easy to solder 2 flash memory 48pin samll pin + eprom 24c16 write protect 7+8= 5volt

if you can use search bouton you can find dumps tested 100/100


@+

[dam495]

yes by dumps if you are professionel soldring it is not easy to solder 2 flash memory 48pin samll pin + eprom 24c16 write protect 7+8= 5volt

if you can use search bouton you can find dumps tested 100/100


@+

i going to need use upa prog, and remov the chip 24c16 read and put the new fille v33 or i just need short or lift the pin 7 and 8 from eprom 24c16? may you help me whith this?

[paul_12345]

depends on the sbb.

I had a v28 that updated to v32 with just pin 7-8 shorted

I got a v31 that wouldn't even connect so would probably have to flash the eproms

[nicole99wu]

hi, guy, as I know it is impossible, the update is by the manufacturers. And now the sbb key is already updated to the v33, you can buy one.

[dam495]

it's possible or not? who are telling the tru?

[dam495]

guys, who made update can put, a video showing how was made the process. it's a good idea

[paul_12345]

Dam495 I already told you read

http://www.digital-kaos.co.uk/forums/f177/updating-duplicate-sbb-fault-169793/index4.html#post837822

all the information is there.

I updated this way as I said, and posted dumps of the eprom that I read after.

Just make sure the program says v33 not the latest v34

[mardude]

Dam495 I already told you read

http://www.digital-kaos.co.uk/forums/f177/updating-duplicate-sbb-fault-169793/index4.html#post837822

all the information is there.

I updated this way as I said, and posted dumps of the eprom that I read after.

Just make sure the program says v33 not the latest v34

Hello Paul! How did you program the flash memory 48 pins? He used a thread adapter? Where to buy it?
thanks

[paul_12345]

Hello Paul! How did you program the flash memory 48 pins? He used a thread adapter? Where to buy it?
thanks

If you had read the thread you would know what I used to read the chips ;)

Willem programmer with cheap adaptors from ebay.