View Full Version : KWP2000+ update
motocarlos
24th July, 2011, 12:10 AM
hello all,
i have this old software, i would know if there it is some update for this tool???
anyone can post it??
Regards to all.
eprommazza
24th July, 2011, 09:26 AM
hello all,
i have this old software, i would know if there it is some update for this tool???
anyone can post it??
Regards to all.
Hello!! i think no.
It old project dead..new of it is mpps same engeener
lolooo1981
24th July, 2011, 10:44 AM
I confirm, no more update.
Best regards
bazare
24th July, 2011, 11:26 AM
Hello!! i think no.
It old project dead..new of it is mpps same engeener
same engineer ... same finality for MPPS - "project dead"
motocarlos
24th July, 2011, 11:48 AM
Thanks to all, and i dont know the MPPS is over too!!!
then with wath we can work on chiptunning??
regards.
lolooo1981
24th July, 2011, 11:59 AM
You have other choice :
Magpro or kess ,bdm100, etc...
I think if they're are no valid update for mpps, yes the project is definitely dead.
Best regards
motocarlos
24th July, 2011, 12:05 PM
You have other choice :
Magpro or kess ,bdm100, etc...
I think if they're are no valid update for mpps, yes the project is definitely dead.
Best regards
i have the flashtec clone, and i have the hardware magpro2 4.0, but for the ecu ed17 like the car of my wife (VW polo 2008 1.4 tdi 80hp) with what i can do the chiptunning??
thanks ,
regards.
lolooo1981
24th July, 2011, 12:52 PM
i have the flashtec clone, and i have the hardware magpro2 4.0, but for the ecu ed17 like the car of my wife (VW polo 2008 1.4 tdi 80hp) with what i can do the chiptunning??
thanks ,
regards.
Maybe edc17CP14 ?
motocarlos
24th July, 2011, 11:10 PM
Maybe edc17CP14 ?
ok but with wath i can do the reading and writhe with a checksum ok for my car??
my flashtec clone with the magprog2 software do that work??
regards.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.