Rover 400

[lupu_sandu]

Hi guys, i have a Rover 400 and customer lost all keys.
Customer don't want immo-off, so i need to make key.
I found alarm module under dash with HC05B16, read but zedbull don't know this dump.
Anyone can give logic key data to write a T5? ( i will post dump in one hour)

LE:
Dump from alarm module (or immobox):

[damih]

Hello Lupu

your PIN is 8518
and logic for T5 is
FF FF F5 04 20 61 05 FF FF FF F5 04 20 61 05 FF

For immoboxe Valeo?

[lupu_sandu]

This is a Lucas immobox:

[obdmaster]

Lupu m8 on rover 400 there is no transponder in key, immo is done by lucas 17TN remote control .

You will need new remote or used. t300 or mvp and make lead as shown here m8

http://www.digital-kaos.co.uk/forums/f177/rover-t3oo-remote-lead-pin-outs-47726/

then program in remote by obd, no pin codes needed m8

[lupu_sandu]

Damn, back to immo off.
Thanks all for help

[ninja123]

lupu, if you have t300 ad100 mvp, you can read key access code via obd, then enter code via drivers door lock and immo is by passed.

You will need to re enter code if battery is disconected.

Or if you have any of above or SBB, just link in another fob, if you have problem locating fob, i can post you a used one, got a bucket full of them mate.

ninja

[auto diag]

Lupu in rover 400 you can read dump in 93c46 .you have two kind MSB or MKC .then post it i make immooff. after you cut pi 13 then the rest is electricity.don't forget telling if it MKC or MSB.
good luck
.

[lupu_sandu]

This is MSB ECU so immo line is on pin 45.
Already immo off.

Once again, many thanks.

[khaledabdulaziz]

could you share how did you do it ?