2008 Nissan Altima 2D 2.5 S has a weird problem

[ledojo]

Symptoms:
When ignition turned to RUN, SRS MIL turns on solid, then off, then flashes continuously with no end.

Also, scantool cannot communicate with SRS system.

What I've done:
I've cleared crash data from module.
I've checked wiring connector for continuity, power and ground.
CAN/K lines all show continuity to DLC.

I don't know what is causing the srsmil to flash like this and why i cant get any codes....

Any input?

[sherl645]

Hi,
What scantool are you using?

Can we see the dump?

Ronan

[ledojo]

Hi,
What scantool are you using?

Can we see the dump?

Ronan

Sure and using OTC Genisys.

This is the crash and clear....

[lwood]

if scanner doesnt pick up module.
just inter self diagnosis mode.
then see the SRS lamp flash, write down the times it flashes. that flashes will tell you what is wrong.

[ledojo]

Thanks... besides what we talked baout before, the scantools still do not comm with srs module... no big deal, i guess.

[credoline]

Yours cleard file looks okay.

[bender]

Yours cleard file looks okay.

I mentioned it before, if you did it once you should know them all
of this type crashed dump.
The cleared dump was not properly cleared.

[ledojo]

I mentioned it before, if you did it once you should know them all
of this type crashed dump.
The cleared dump was not properly cleared.

I don't have car right now, but would you give me more insight? I'm always trying to learn new things here and I accept any and all feedback.

[credoline]

I mentioned it before, if you did it once you should know them all
of this type crashed dump.
The cleared dump was not properly cleared.

If you how to do it exactly, help to Ledojo.

[morfej]

I have a clear to test out. Solution has been tested on similar sentra.

br