Mercedes R320CDI DPF-off

[bobolin4o]

Is there any workable solution for DPF-off on this car?
Tried with ECUsafe without success... The problem is damaged differential sensor, MIL not on, DTC not found (after ECUsafe) of course, but car is stil in limp mode...
Here is dump from ecu, read with MPPS.

[grinovsky]

the solution is to replace the differentiel sensor by a new one

[bobolin4o]

I know this, but I want to permanently remove the DPF
So to achieve this, you install a new sensor?

[oem]

You can use emulator for sensor and then make DPF off with ecusafe.

[grinovsky]

I know this, but I want to permanently remove the DPF
So to achieve this, you install a new sensor?
yes,my freind,or use emulator diff sensor like say oem

[macxlulu]

yes,my freind,or use emulator diff sensor like say oem
I disable fap and regeneration in 3.2 cdi with some person I know did, I tried for 4 cars only one I did .....

[grinovsky]

I disable fap and regeneration in 3.2 cdi with some person I know did, I tried for 4 cars only one I did .....
i have done fap off for mercedes benz ML classe 320 cdi with no succes (limp mode +no dtc) the cause was cut wires of differenciel sonsor ender the engine,after repair the cut wires,DPF OFF come succes,no limp mode and no dtc
regard's
grinovsky

[bobolin4o]

That's right, but i want permanently remove the diff sensor from dump...
It's any solution for that? For example, where a linear response curve of diff sensor...
I found where are the limits of the sensor readings and achieved a diagnosis 0mb at disconnected sensor, but without effect...
If anyone has damos will be grateful...
P.S.
I have no many more attempts, they will reach the limit for flash via OBD ... but with BDM is a nightmare, that
whichever opened the EDC16 Mercedes knows what it is...
Regards!

[gaiex]

Can anyone confirm me if is safe to load the dump file generated by ECUsafe 2.0 (DPF, EGR, speed limiter OFF) to my car CLK320CDI ?

I have MPPS v3.0

I want to deactivate DPF filter electronicaly, since I removed it physicaly and it's ok without Engine ligth, but every 1000km it regenerates, only have in DAS this error: DPF air flow to low.
I tryed with ECUSAFE2.0 but don't know if its safe to load dump to ECU!?

PS: I also want to deactivate the speed limiter and if possible also EGR.

Any one can help please?

Regards

[EcoPowerUK]

Ecusafe is good for nothing, get someone to remove manual by turning the Dpf switches off not masking dtc table like with Ecusafe crap,

Phil