Toyota odometer need help.

[Dylan Chin]

Hi All Dk.
I have a toyota Gaia need odometer collection.
Can someone give me advise.

I thinks maybe can direct some wire from the socket to complete the job with tacho programmer(like ford ranger).Bcos i did see the eeprom(maybe i need check more details)
Help.

DId dk mate got experience about this odometer.
Thanks so much

[Dylan Chin]

WHO KNOW HOW TO CHECK IT ON THE TABLE.
PLEASE HELP ME..THANKS

[pinkfloyd5eg]

WHO KNOW HOW TO CHECK IT ON THE TABLE.
PLEASE HELP ME..THANKS

it should have Yazaki 93C46 EEPROM ,, read the dump and post it for calculations.

[Dylan Chin]

Thanks for you reply.
I have find a eeprom(but i cant see 93c46/93c56)

I have change the mile but i not sure success or not and the car not here.

May i know how to check it on the table?

[pinkfloyd5eg]

Thanks for you reply.
I have find a eeprom(but i cant see 93c46/93c56)

I have change the mile but i not sure success or not and the car not here.

May i know how to check it on the table?

please post the original and the modified dump files(you should save them) , also post the original and the modified km value ,, then we can check them for you.

[Dylan Chin]

please post the original and the modified dump files(you should save them) , also post the original and the modified km value ,, then we can check them for you.

The original is 189102km,then the modify one is 62317km

[gijsvm]

Think it`s wrong.
Try these

[pinkfloyd5eg]

The original is 189102km,then the modify one is 62317km

yes friend , the modified dump is fine (correct mileage). but you will need to swap bytes.

[Dylan Chin]

Thanks mate.
Can close file^^
But still need double check at car,comfirm every things is ok.
Thanks again

[pinkfloyd5eg]

Thanks mate.
Can close file^^
But still need double check at car,comfirm every things is ok.
Thanks again

you are welcome ,, but don't forget to swap the bytes of your modified dump ,, it shows mileage 05 13 while for correct mileage, bytes should be 13 05 . exactly as the second dump (part2) , which I didn't notice when you have posted it :):)

good luck.

[Dylan Chin]

i think i have change it in the modify file.

[pinkfloyd5eg]

i think i have change it in the modify file.

use the file in post #7 by (gijsvm) ,, it is ready and correct, just write it to the EEPROM ,then job done.