PDA

View Full Version : BMW cas white



zhvepes
29th September, 2011, 10:36 AM
Hello

Please need your help

Have a bmw e60 530d with EWS Tampered error.

I think the problem stay in flash because the eeprom shows the correct VIN, please can you check the files attached?

I have the 9s12x gold box.
Please............!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

cas2
hw-02
sw-13.2
cod-05
diag-index-0690

DottoreBL
29th September, 2011, 11:05 AM
eeprom is ok

zhvepes
29th September, 2011, 11:14 AM
Can you send me a good flash for this?

DottoreBL
29th September, 2011, 11:19 AM
i do not have flash

zhvepes
29th September, 2011, 11:23 AM
Can i write another flash from another cas 2?

simon77
29th September, 2011, 12:25 PM
ews tamper error try cas engine sync with gt1 inpa should start.
regards

zhvepes
29th September, 2011, 04:02 PM
I tryed with GT1 but it can't do sync i try also with inpa but same thing. Also i have a fault in DDE for eeprom error, but i can't reprogram it because cas is in ews tampering.

Any suggestions?

maaxxyy
29th September, 2011, 09:28 PM
What is the issue with the car? Non start? Warning lights etc?

simon77
30th September, 2011, 06:40 PM
have you tried to make keys or adjust miles and got these errors or the car came with this problem need some mor info for us here to help out.
regards

zhvepes
1st October, 2011, 03:10 PM
Hello, thank you for your reply.

Yes, the car came like this

I have 2 errors in the ecu

EWS Tampering
ECU eprom internal fault

This is also the ecu eprom readed 95160

Please do your best

zhvepes
1st October, 2011, 04:19 PM
I have read it with enigma

simon77
2nd October, 2011, 12:59 PM
i have had the same problem before after somone with auto logic was playing around with sterring lock!.
what i had to do was use ncs or sss and encode all car then i used gt1 for cas reset and then cas dme sync all was good after that .
regards

zhvepes
2nd October, 2011, 07:48 PM
I also have tryed with sss and with autologic also but still have the same errors. When i try with sss, Load SW it's not activatet at all.
I don't have bdm to flash the hole ecu. Also have tryed with another ecu changing only the eeprom 95160 and still i can't make the cas-dde sync.
Every thing else i can do?
Please i have to do this...

bmw320d
3rd October, 2011, 07:58 PM
if you haven't do changes, with gt1 can to do alignment ews-dde, I have do it many times without problem, you go on service DDE the ews alignment?

zhvepes
3rd October, 2011, 09:39 PM
Yes, alredy tryed with inpa, gt1 and autologic also, but same error, if you can check the dumps attached you will do me a great favor.