View Full Version : Honda Civic 77960-SMG-E021-M1 crash data
PierreTheron
29th September, 2011, 01:07 PM
Hi
Have tried a few cleared files on here but i still have faultcode
54-10 SRS Control unit internal failure-Present.
Can someone please clear this crashed file for me.
Vehicle is Honda Civic 2008
Help would be much appreciated.
Pierre
rrador
29th September, 2011, 02:30 PM
this should be good
PierreTheron
30th September, 2011, 11:12 AM
Hi
RRador
your file also not working .
Can clear faultcode till next time i switch of ignition and switch on . Then faultcode is back ..
Pierre
raimi.s
30th September, 2011, 03:34 PM
Hi
Have tried a few cleared files on here but i still have faultcode
54-10 SRS Control unit internal failure-Present.
Can someone please clear this crashed file for me.
Vehicle is Honda Civic 2008
Help would be much appreciated.
Pierre
try this and report please
PierreTheron
2nd October, 2011, 07:59 AM
Hi mate
Still no luck .
Still have fault 54
Regards
raimi.s
2nd October, 2011, 09:46 AM
Hi mate
Still no luck .
Still have fault 54
Regards
here is clear and tested .
password same
raimi.s
4th October, 2011, 10:03 PM
one more damp
cesarjaramillo
4th October, 2011, 10:43 PM
File cleared. Good luck.....
Hi
Have tried a few cleared files on here but i still have faultcode
54-10 SRS Control unit internal failure-Present.
Can someone please clear this crashed file for me.
Vehicle is Honda Civic 2008
Help would be much appreciated.
Pierre
PierreTheron
7th October, 2011, 11:35 PM
File cleared. Good luck.....
Hi Mate ...
Tried your file as well. Can clear fault code as well but fault is back as soon as switch on ignition .
Have used 2.2 ohm resistor for driver airbag (Stiil waiting for new airbag to arrive)
Am going to get another airbag ecu as i now believe that fault must be inside ecu.
( I see that my file read with vp490 have got an extra line .the last line , does it make a difference??)
Have used another airbag ecu E120 but this have driver airbag with two plugs connected to it . This file seems to clear all faults except driver airbag.If put resistor it fault circuit one . If short wires it puts fault circuit two.
Thanks for all help from all friends on DK.
:beer::beer::beer:
PierreTheron
10th October, 2011, 07:29 PM
Hi
Just an update.
Have got another airbag unit that had 3 fault.
Cleared some data that i think was the crash lock data on it and installed .
Switched on ignition and airbag light switched off and stayed off.
Did Diagnostics and all was good .
Tried to clear old airbag unit the same way and it came up with 54-10 again.
:manutop::top:
This time i used a different programmer on the second ecu i got and all went well.
Regards
Pierre
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.