VW Bora 2001y EDC15VM+ Bosch 0 281 010 651

[workas]

Hi ,can someone help with dump of flash AM29F400BT and eeprom 24c04
I tried to write eeprom from another control module edc15 after learning process everything alright ,but glow blinking on dash and error internal control module eeprom error

Car was stolen ,after that immo light on dash blinking in ENGINE ecu:

Address 01: Engine Labels: Redir Fail!
Control Module Part Number: 038 906 012 FB
Component and/or Version: 1,9l R4 EDC 0000SG 3350
Software Coding: 00002
Work Shop Code: WSC 01266
Additional Info: WVWZZZ1JZ2W179595 VWZ7Z0A4027490
VCID: 55AA846A859A
1 Fault Found:

18048 - Internal Control Module: EEPROM Error
P1640 - 35-00 - - r
Thanks in advance

[keygargoil]

if you fit new ecu and reprogramme the keys with pin from dash it should be fine

[mati-rk]

Hi! Just try adapt ecu to dash vith vag-com. 01 motor, adaptation, channel 50 old login than write as new value login from dash and recode keys. If it still won?t work you will need dump from the ecu with same vag number and then adapt with dash and it must works. :top:

[workas]

Hi! Just try adapt ecu to dash vith vag-com. 01 motor, adaptation, channel 50 old login than write as new value login from dash and recode keys. If it still won?t work you will need dump from the ecu with same vag number and then adapt with dash and it must works. :top:

I already done this procedure ,i'm looking for dump ,maybe someone have it ?

[workas]

somebody hellp me !!! :(

[Bllinda]

You should help this device (http://a-dalys.lt/index.php?option=com_hikashop&ctrl=product&task=show&cid=4&name=vas-5054a&Itemid=57&category_pathway=0), my cheapest found.

[H.Wessel]

hi

VWZ7Z0A4027490-WVWZZZ1JZ2W179595
Pin code: 5162

the problem is that flash had been changed, when ecu booting it detect checksum in flash failed (P code)

read flash, calculate checksum and write back :)

best regards
H.W

[pawliukazz]

hi

VWZ7Z0A4027490-WVWZZZ1JZ2W179595
Pin code: 5162

the problem is that flash had been changed, when ecu booting it detect checksum in flash failed (P code)

read flash, calculate checksum and write back :)

best regards
H.W
If the flash checksum was incorrect, the ECU wouldn't boot itself in the first place, which means - no glow plug light on... The problem is that eeprom content (not flash) doesn't match what ecu needs. need different dumps...

[chiorbeq]

Your problem is in flash.Reflash the memory and the ECU work.