View Full Version : megane 02810019696
Fermin
4th October, 2011, 11:24 PM
Anyone wanting to help a novice to reprogram a megane 1.9 DTI ECU 0281001296, where's the map of the injection, I got another ecu and removed the immo, lack try. Thanks in advance
arielcalcaterra
5th October, 2011, 02:59 AM
Anyone wanting to help a novice to reprogram a megane 1.9 DTI ECU 0281001296, where's the map of the injection, I got another ecu and removed the immo, lack try. Thanks in advance
Post the two files 29f010.
Fermin
5th October, 2011, 10:22 PM
thanks, I have to unsolder 29f910 and read the two, did not know they were in those memories. Step by step.
Thank you very much again.
nicamarcos
5th October, 2011, 11:46 PM
02810019696, 0281001296,??? you decide :), boths bosch numbers not exist.
I think that must be 0281001969, right? if yes then you not will find 29f010, you will find 27c1001 otp plcc eproms.
Fermin
6th October, 2011, 09:54 PM
yes , sorry 0281001969,yes i found 27c1001 .ok,
Today I started the car with the ECU to remove immo, no problem. Now I have to desolder the 27c1001. Another step closer. I hope not to break unsolder
thank you very much
Fermin
12th October, 2011, 04:10 PM
I managed to desolder one of the 27c1001, I have to buy an air soldering station, another thing not let me see the file ecm2001 program, the number of sw is 7700113863.
Thanks in advance.
Fermin
12th October, 2011, 10:26 PM
Maybe I have to read both eeprom and attach the file?.
bts
12th October, 2011, 10:35 PM
Maybe I have to read both eeprom and attach the file?.
Try this.:top:
AM29f010
Fermin
29th October, 2011, 02:23 PM
86347
86348
I dont found ecm2001 drivers or damos file .
SW 7700113863
HW 0281001969
I stand at this point. ...
Perhaps this is complicated to begin with.
Thank in advance
bobolin4o
29th October, 2011, 02:43 PM
Those files are a crap...
Read the chips again
Fermin
29th October, 2011, 07:48 PM
I think I misread the file, you are absolutely right., Because I was getting checksun different.
I think these are good.
thanks
bobolin4o
31st October, 2011, 09:29 AM
I think these are not good again...
Fermin
1st November, 2011, 04:16 PM
test, test, test. and nothing ever come out the same results. Same checksum. I have read two of tdi Cordoba (ahu) and there they let me see the map in 2001 and winols ecm. But the Megane anything.
Break them to desolder?.
If they had broken no data would not leave it?
Thanks in advance
Fermin
2nd November, 2011, 12:06 AM
While I believe that now I do. resolder the pins on the chip and the checksun change one of them.
With winols 26 possible maps, maps ecm2001 injection.
Now to test.
Little by little.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.