Citroen saxo 16v 1AP41

[moky]

hi all,

i need solution for immo OFF on saxo vts 120hp ecu 1AP41 (1999).

need to desolder tms374 ? or solution on flash 28f512?


thx a lot !

[KILL_THE_IMMO]

28F512 this is the eprom

[gadroulll]

when you make the 30 sec i think that you must have connected th immobox .
after you desconnect immobox ,change eeprom and try to start the car , you may need to do this more that 1 times to remove immo.

the other way is to lift the pin that you connect from tms370 and make eeprom all ff

[scs-mem]

Here buffalo for tms
Remove ecu replaced 28f512 with one with programmed this buffalo.bin,
cut immo pin
put ecu in car
turn on ignition for 40-50 sec
Remove ecu from car and put back original 28f512
Put ecu in car ,should be start without immo.
If have trouble repeat the procedure

[moky]

Many thanx all !

I will test and report

[tiguan]

Here buffalo for tms
Remove ecu replaced 28f512 with one with programmed this buffalo.bin,
cut immo pin
put ecu in car
turn on ignition for 40-50 sec
Remove ecu from car and put back original 28f512
Put ecu in car ,should be start without immo.
If have trouble repeat the procedure


password.........Please...??

[gustavo f grasso]

Here buffalo for tms
Remove ecu replaced 28f512 with one with programmed this buffalo.bin,
cut immo pin
put ecu in car
turn on ignition for 40-50 sec
Remove ecu from car and put back original 28f512
Put ecu in car ,should be start without immo.
If have trouble repeat the procedure

SORRY FOR THE INCONVENIENCE
I could spend THE PASSWORD OF THIS FILE NOW I HAVE A PROBLEM WITH THIS TYPE CENTRAL
THANKS

[potterfaster]

Hello!
Pls sent me the password.
Many thanks
Regards