c16man
21st October, 2011, 06:09 PM
Hey guys, I have a ECM that keeps loosing its FLS setting.
I have reflashed the ECM, but still the same problem. When I enter the FLS value, the value stays, but the parameter mismatch fault is still active and when I change to another screen and come back to configuration the FLS setting is gone.
Is this a failure of the non-volatile memory?
Can this be repaired?
It is an ACERT machine C18 Ser prefix EJG.
Thanx in advance.
I have reflashed the ECM, but still the same problem. When I enter the FLS value, the value stays, but the parameter mismatch fault is still active and when I change to another screen and come back to configuration the FLS setting is gone.
Is this a failure of the non-volatile memory?
Can this be repaired?
It is an ACERT machine C18 Ser prefix EJG.
Thanx in advance.