toyota 89780-35010

[shanektm450]

Hi I have a problem zedbull produces chip tpx1 but no start only cranks can some just look at dump below 93lc66 and give me :saint:key data my data from zedbull is ( I have tried 3 boxes same thing, if i do byte swap then car starts and cuts!! ) Tris:7E561D0427000000005FF87E0000
Thanks
Shane

[igorr]

did you chose 8 or 16 bit when you upload bin in zedbull eeprom aplication

[bram380]

Your key is:

[shanektm450]

did you chose 8 or 16 bit when you upload bin in zedbull eeprom aplication
I read it under 8 and 16 bit same problem zedbull sees it and produces chip with key data but it looks all mixed up if I look at Tris data!!:beer:

[KILL_THE_IMMO]

hi i had this problem
the solution is write image file created by zedbull into immobilizer eprom
good luck

[shanektm450]

hi i had this problem
the solution is write image file created by zedbull into immobilizer eprom
good luck

Sorry you mean I must create image file after I produces the transponder or before?????
Thanks
Shane

[KILL_THE_IMMO]

i will tell u what i done in firt time i produce 4c transponder
but car still not work crankkk
after i return and i write image created file into eprom and the car start

[igorr]

program transponder then create image file dont remove transponder from zedbull during this proces and then write new file to eeprom

[KILL_THE_IMMO]

i remember that i created file and after programm new key

[KILL_THE_IMMO]

and after write image file in eprom

[ngakson2002]

here you go friend.Program the original immo box of the car with this.Start the car and send me result.

Good luck