PDA

View Full Version : Galetto 1260 no read anything.


Fec001
29th October, 2011, 04:32 PM
I have a new galetto 1260 and doesn't read anything. I tried many EDC15 ECUs, now I'm trying to read clio 1.4 sirius 32 ecu bot no success. Anyone know solution?
Fec001
29th October, 2011, 05:02 PM
I have G540 eprom flash programmer and it can read 29F002BB, but I don't think so the 29F200BB can be read with it.....
levisdj
30th October, 2011, 08:21 PM
Clone tool ?
gad3n
30th October, 2011, 10:09 PM
bad tool 100% ... have read many edc15 no problem with it
Fec001
31st October, 2011, 05:14 AM
yes it is clone
diagmaster
31st October, 2011, 07:46 AM
can BDM100 do this?

I have a new galetto 1260 and doesn't read anything. I tried many EDC15 ECUs, now I'm trying to read clio 1.4 sirius 32 ecu bot no success. Anyone know solution?
Kuba_KMS
31st October, 2011, 10:40 AM
Galetto with L line can read Sirius 32 with no problem. It's old ECU which need wake-up on L line. It's KWP2000 slow init with 5 baud speed on L line, after slow init you can normally communicate with fast KWP2000 protocol on K line.

Best regards

Kuba
alfabit
31st October, 2011, 11:10 AM
I have a new galetto 1260 and doesn't read anything. I tried many EDC15 ECUs, now I'm trying to read clio 1.4 sirius 32 ecu bot no success. Anyone know solution?

Galetto1260 no chance to read Siemens sirius 32/32n/ems3132 used on clio, logan and many others. No line L = no wake up ecu = no read.
You find here on this wonderful dk forum tons of posts about this problem Galeto + sirius !
Fec001
31st October, 2011, 11:13 AM
can BDM100 do this?

dont think so
Fec001
31st October, 2011, 11:15 AM
Galetto1260 no chance to read Siemens sirius 32/32n/ems3132 used on clio, logan and many others. No line L = no wake up ecu = no read.
You find here on this wonderful dk forum tons of posts about this problem Galeto + sirius !

The problem is that, I don't know my galetto is working for sure but it is new
alfabit
31st October, 2011, 11:29 AM
The problem is that, I don't know my galetto is working for sure but it is new

New probably has NO line L ( pin 15 ).
Look inside if you can open the case, must be connected pins 4,5 ( GND ), 7 ( line K ), 15 ( line L ), +12V ( line 16 ), +12V APC ( line 1 )
And you can connect a 2 LEDs from +12V to line K and line L by a 1k resistor for each LED and try to give " read " command from galeto sw and see if the LEDs are blinking.
K,L must both blink when try to read slow init ecus ( sirius32, EMS... )
No blink, no work.