Honda Accord 2.2 CDTI

[markovojvodic]

Hello , i have a problem with this Honda,

ECU is 0281012582 EDC 16

ECu came to me as a fault with comm, when you push 29BL802C car starts, after you release it it doesnt

With BDM i could only communicate with MPC556 and eeprom, no comm with 29bl

i replaced it and found that its broken form lower side

then i programed it with another SW from same ECU with same HW number but nothing car doesnt start at all, but with BDM i communicate normally

Any idea ?

Cheksum is ok but im not sure is dump from MPC 556 corrupt or not ?

[easytech]

The software number in the EEprom does not match the software number from the BL dump.
What is the hardware number?

[markovojvodic]

0281012582


---
I am here: http://maps.google.com/maps?ll=45.770048,15.800633

[easytech]

I will take a look at my other PC tomorrow, but I can't remember having this HW number.
I do have a virgin of 013 407 somewhere if this help.

[easytech]

I have a virgin file from a newer ecu maybe this will help you.

[markovojvodic]

DOES ANYONE HAS COMPLETE DUMP FROM AN ECU WITH SAME HW NUMBER ?

ALSO PINOUT WOULD BE GOOD

[markovojvodic]

Any idea ?

on Honda is it possible to put another ECU only be replacing eeprom content or not ?

[easytech]

Can't you get the virgin working?
I realized later that it is CMD BDM, the MPC read is slidly different than with BDM100 or others.

[markovojvodic]

im puting car aside until weekend , then i will have time to play with it .............. when i put virgin, i dont have a tool to programm it , ?

[markovojvodic]

i read it with Dimsport BDM

[easytech]

I don't know if Dimsporttool can handle the MPC file from CMD.
After that you need Honda tool to program keys and injector coding.

[markovojvodic]

finally i have communication and only error i have is P0602

Any idea anyone ?

[markovojvodic]

ECU is ok , which tools can do coding on this honda, i have brainbee, t 300 etc.... but dont have honda original

[easytech]

I do this usually with ori Honda tool or Snap-on.
I don't know if others can do this.

[markovojvodic]

Maybe im asking stupid question - Launch ?

[markovojvodic]

i only have DTC P0602 - control module incorect programming....

[elangel0001]

Solution!!

ECU Rewrite + HDS
to me the same thing happened last week.

[markovojvodic]

What do you mean by HDS ? original Honda diag tool ?

if its it doesnt work

[elangel0001]

HDS clone This is what I have http://www.ebay.es/itm/HONDA-Acura-CAN-BUS-Diagnostic-System-HDS-HIM-Kit-/260813137859?pt=UK_Diagnostic_Tools_Equipment&hash=item3cb9aca7c3

[markovojvodic]

Where is immo on Honda - or to be exact , what do i need to start the car with set from another - engine ecu, keys and where or what is immo ?

[elangel0001]

hello

Just connect the HDS and use the ("ECU Rewrite" software).
Changes SW and everything is in the immobilizer ECU

will change everything, the updated file is over 3000kb

regards

[markovojvodic]

SOLVED.....bought another ECU replaced eeprom content and thats it