Renault Koleos 280380655R

[kikikis2001]

Hello, I've CAN module interface in Koleos nr 280380655r. I've read eeprom 93c66 from this box and change ID in file 655r_POP.bin (created from 655r_org.bin). But when I've write in 93c66 eeprom with changed VIN, Renault CLIP don't see new VIN, but only "YYYYYYYYYYY" also part number is not 280380655r, but ....705R. Probably problem is with checksum - mayby You could help me change VIN in right way (orginal file is 655r_org.bin and new VIN is written inside 655r_POP.bin). Best regards.

[mariooo]

Hello, I've CAN module interface in Koleos nr 280380655r. I've read eeprom 93c66 from this box and change ID in file 655r_POP.bin (created from 655r_org.bin). But when I've write in 93c66 eeprom with changed VIN, Renault CLIP don't see new VIN, but only "YYYYYYYYYYY" also part number is not 280380655r, but ....705R. Probably problem is with checksum - mayby You could help me change VIN in right way (orginal file is 655r_org.bin and new VIN is written inside 655r_POP.bin). Best regards.
As you read the 93c66?

you read 8 bit or 16bit?

you wrote 8bit or 16bit?

I do not think there are changes between two files as you ever read the original file and then you write the same file?

[kikikis2001]

Hello, I've read 93C66 by EEprom Programmer from noimmo - Equipment (http://noimmo.lt/equipment/params/111/) - file 655r_org.bin
I've changed only VIN inside this program (...9710) and then write file 655r_POP.bin. Unfortunately, Renault Clip see CAN module, but with other serial number and with VIN "yyyyyyyy", but when will write old file, VIN and SN is OK. Mayby I should also change inside the file numbers 2779 (it is end of old VIN) and write new 9710? I don't know if programmer read 8 or 16 bit. Best regards.

[mariooo]

Hello, I've read 93C66 by EEprom Programmer from noimmo - Equipment (http://noimmo.lt/equipment/params/111/) - file 655r_org.bin
I've changed only VIN inside this program (...9710) and then write file 655r_POP.bin. Unfortunately, Renault Clip see CAN module, but with other serial number and with VIN "yyyyyyyy", but when will write old file, VIN and SN is OK. Mayby I should also change inside the file numbers 2779 (it is end of old VIN) and write new 9710? I don't know if programmer read 8 or 16 bit. Best regards.
there must be a conflict between the 93c66 you wrote with the new VIN and other content such as chips inside ... interior unit perhaps the frame number is contained in two units and then if you change one conflict do ..