renault megane 1.4 siemans s111730108c

[busaman]

renault megane 1.4 siemans s111730108c does anybody have immo off solution i have renault decode tool but its not listed

[PierreTheron]

renault megane 1.4 siemans s111730108c does anybody have immo off solution i have renault decode tool but its not listed

Hi

So not fenix rubber filled??
Have seen one of these i think . Is ecu rubber filled ?
Tms chip ?? If you can find in rubber. Try tweeser method .

Bridging off pin with voltage supplied>>
:captain:

[busaman]

no not rubber filled i think siemens/bendix

[Zohar]

Hi.

You need to read dump from MCU HC11E9 and then fill FF in all sectors of eeprom and write dump back to MCU. And do not forget to cut immo line to ECU before placing ECU on car. This is 100% tested solution.

BR

[busaman]

can i write to mcu without taking of the board( if i can what pins to connect) i have no socket for this on my programmer.

[Zohar]

can i write to mcu without taking of the board( if i can what pins to connect) i have no socket for this on my programmer.

Yes, inscheme programming is possible.
Lift pin RST before reading MCU and you should connect osciloscator pin from programmer to mcu.

On this picture connections for X-Prog:

[busaman]

ok i have carprog and this one is not listed hcp11e1vfn annd have no socket for wellon any other solution,

[Zohar]

try to program inscheme as HC11E1 (bootloader and eeprom area is similar to HC11E9)

[busaman]

try to program inscheme as HC11E1 (bootloader and eeprom area is similar to HC11E9)

tried that does not work.
br

[sogaro]

Same chip inside Mercedes ML ECU, use AK400, works everytime.