Golf 4 Login Code Reader? Motometer 1J0 920 801 B

[gixxer]

Hello

What, device I can read PIN by OBD plug a Golf 4 '99 ??

Part No: 1J0 920 801 B
Component: KOMBI+WEGFAHRS. BOO V13

(k+can 2.5 and vagtacho 3.01 NOT read...)

Thank You very Much!!

[cosmind]

reset the dash and try again with k+can
or use vag eeprom programmer 1.19

[gixxer]

reset the dash and try again with k+can
or use vag eeprom programmer 1.19

Hi
I tried by vag epprom programmer , but when I would like reading eeprom and connect to dash, stop the read and pop-up this message "wrong software version"

How to reset the dash? If I reset, not lost immo-key data?
(sorry stupid question :))

[lupu_sandu]

Pull out fuse for 2-3 minutes, or remove battery.

[SirshenG]

Do u have T300??

[gixxer]

Do u have T300??

No ... :(
T300 read??

[SirshenG]

Yes It does read most motometer clusters but takes up to 4 hours....:turtle:

[Rito]

Hello

What, device I can read PIN by OBD plug a Golf 4 '99 ??

Part No: 1J0 920 801 B
Component: KOMBI+WEGFAHRS. BOO V13

(k+can 2.5 and vagtacho 3.01 NOT read...)

Thank You very Much!!

B00 only via epron....
Poste here dump

[workdamnyou]

T300 wont go near it, dont waste your money.

AD only added it to pro units a couple of months back so even if you buy the "2011 Super T300 V11.whatever" it wont do it.

[Rito]

T300 wont go near it, dont waste your money.

AD only added it to pro units a couple of months back so even if you buy the "2011 Super T300 V11.whatever" it wont do it.

Can you put link for new t300???
I never see it...

[workdamnyou]

Can you put link for new t300???
I never see it...

You missed my point. There is no new T300. Just chinese wrapping paper and fake software versions to make you think there is.

AD stopped software updates at V7.something for non pro units, so anything after that is just a lie.