OPCOM will not program corsa c cluster??

[madman47]

Hello,
Im trying to program the cluster on a 03 corsa c with OPCOM china clone (latest clone version 2010) everything programs fine, ecm, bcm, but when trying to program cluster, it comes with error message "programming failed". Yes ive entered the correct security code.
I then used a genuine tech 2, and works fine.
Anyone else found this fault??

Cheers

[mastaflex]

may be you have to reset it before. when controller is not in reset state , it does not accept programming

[pepi]

Your corsa C cluster is with NEC inside .You cant do it with this tool.

[z786]

did u hold the trip reset button??

[mavi]

Hello

with op com is very hard do the job because only write 50%.
Read and write with upa with adaptator nec.

Solve your problem.

Regards

Mavi

[jarfm]

As z786 (http://www.digital-kaos.co.uk/forums/members/67210-z786/) said, hold trip reset button while programing. works 100%

[bodzio012]

I've heard the dash programming does not work reliably in version 1.44 maybe you have this version

[madman47]

Hi, just to clarify, im not trying to modify the ODO, im just trying to reprogram cluster when changing an engine ecu. You need to tell the cluster, BCM and new ECU what options are in the vehicle, eg, transmission type, abs or not, cruise or not, etc etc

[drakov]

latest clone version 2010
Latest clone version of Opcom is 3/2011

90% of opcom clones have issues when programming/adapting, ask anyone with genuine unit who has had the pleasure of earning from these issues:-)

[DB77AAA]

OPcom whith FW 1,44 and 1,43 and software 08.2010 China clone not working great whith Corsa C instrument or KM adjustement.
But whith FW1,39 and China Clone 08.2010 can adjust KM.
Maybe that is problem.