Citroen C5 Marelli ECU not found

[JaboJG]

Hey guys

I bought an MPPS v12 to dump my Citroen C5 2.0 petrol Marelli 6LPA ECU as it's been newly added as a supported car.

I've tried all the options in the MPPS software and all key positions but I can't get the ECU to wake up.

It has good green voltage levels.

The software doesn't have any notes on it about fuses or anything.
Any recommendations what to try?

[gezame]

Hi
you cand do in Boot-mode.
Regards.

[JaboJG]

Hi
you cand do in Boot-mode.
Regards.

How do I put it in boot mode?

[JaboJG]

I mean I've got this pin out http://i717.photobucket.com/albums/ww178/JaboJG/Peugot_Citroen_IAW6LP140_MM6LP.jpg

Just not too sure atm what to do with it.

[JaboJG]

Ok so far I've found that I've to use the ST10F280 option in the MPPS software to boot mode the ECU.
The software says put micro pins 4 and 5 to ground. Seems different from the diagram I posted though, no?

[JaboJG]

Okay

http://i717.photobucket.com/albums/ww178/JaboJG/st10f280.jpg

Ignore the 100 Ohm resistor. Have I pointed to the number 4 and number 5 pins correctly?

[JaboJG]

Right that picture might not be my ECU because supposedly there's 3 potential component layouts, according to the attached PDF file.

I will open my ECU tomorrow and will probably be back for more help lol